| Code |
Description |
| G00 |
Rapid positioning |
| G01 |
Linear interpolation |
| G02 |
CW circular interpolation |
| G03 |
CCW circular interpolation |
| G04 |
Dwell |
| G05.1 Q1. |
Ai Nano contour control |
| G05 P10000 |
HPCC |
| G10/G11 |
Programmable Data input/Data write cancel |
| G17 |
X-Y plane selection |
| G18 |
X-Z plane selection |
| G19 |
Y-Z plane selection |
| G20 |
Programming in inches |
| G21 |
Programming in mm |
| G28 |
Return to home position |
| G30 |
2nd reference point return |
| G31 |
Skip function (used for probes and tool length measurement systems) |
| G33 |
Constant pitch threading |
| G34 |
Variable pitch threading |
| G40 |
Tool radius compensation off |
| G41 |
Tool radius compensation left |
| G42 |
Tool radius compensation right |
| G43 |
Tool offset compensation positive |
| G44 |
Tool offset compensation negative |
| G45 |
Axis offset single increase |
| G46 |
Axis offset single decrease |
| G47 |
Axis offset double increase |
| G48 |
Axis offset double decrease |
| G49 |
Tool offset compensation cancel |
| G53 |
Machine coordinate system |
| G54 to G59 |
Work coordinate systems |
| G54.1 P1 to P48 |
Extended work coordinate systems |
| G73 |
High speed drilling canned cycle |
| G74 |
Left hand tapping canned cycle |
| G76 |
Fine boring canned cycle |
| G80 |
Cancel canned cycle |
| G81 |
Simple drilling cycle |
| G82 |
Drilling cycle with dwell |
| G83 |
Peck drilling cycle |
| G84 |
Tapping cycle |
| G84.2 |
Direct right hand tapping canned cycle |
| G90 |
Absolute programming (type B and C systems) |
| G91 |
Incremental programming (type B and C systems) |
| G92 |
Programming of absolute zero point |
| G94/G95 |
Inch per minute/Inch per revolution feed (type A system) |
| G98/G99 |
Inch per minute/Inch per revolution feed (type B and C systems) |
| G96/G97 |
Constant cutting speed (Constant surface speed)/Constant rotation speed (constant RPM) |
